Oil Pressure Below Minimum Value - BRP Rotax 915 i A Series Maintenance Manual

Exceeding up to max. 160 °C (320 °F)
Step
Exceeding over 160 °C (320 °F)
Step

OIL PRESSURE BELOW MINIMUM VALUE

General note
If the oil pressure falls below the minimum value, other limits are often exceeded,
NOTE
Any exceeding of the min. admissible oil pressure must be entered by the pilot in-
to the engine log book, stating duration extent of excessive pressure and pertinent
details.
Effectivity: 915 i A Series
Rev. 1
BRP-Rotax
MAINTENANCE MANUAL LINE
Table 3: Excess temperature up to max. 160 °C (320 °F) max. 15 min.
Procedure
1 The whole oil system must be inspected, repaired or overhauled in accord-
ance with the BRP-Rotax instructions for continued airworthiness.
2 Inspect oil level in the oil tank.
3 Inspect oil cooler for contamination and check the entire oil circuit for cor-
rect functioning.
4
Check that oil lines are routed correctly and undamaged.
5
Cut oil filter housing and inspect filter mat for foreign matter.
6 Carry out oil change.
7
Inspect all further systems for correct functioning.
Table 4: Excess temperature over 160 °C (320 °F) for longer than 15 min.
Procedure
1 The whole oil system must be inspected, repaired or overhauled in accord-
ance with the BRP-Rotax instructions for continued airworthiness.
2 Inspect all further systems for correct functioning.
3 Carry out detailed inspection of the affected engine components.
4 The whole oil system (oil cooler, oil lines) must be inspected.
5 Cut oil filter housing and inspect filter mat for foreign matter.
6 Carry out oil change.
e.g. the oil temperature. Please observe the relevant instructions.
ATTENTION
05–50–00
Page 23
June 01 2019