Oil Filter Removing - BRP Rotax 915 i A Series Maintenance Manual

Step

OIL FILTER REMOVING

General note
use ORIGINAL-ROTAX®- oil filter only. Only these filters will ensure correct pres-
At every oil change, unscrew the oil filter and cut open using special tool taking care not to
produce chips.
Special tools To carry out the procedure the following tools are necessary:
12–20–00
Page 28
June 01 2019
MAINTENANCE MANUAL LINE
Procedure
6 Install new oil filter.
7
Pour in approx. 3 l (0.8 gal (US)) of fresh oil.
8 After carrying out the oil change, the engine should be slowly cranked by
hand in the direction of engine rotation (approx. 20 turns) to completely refill
the entire oil circuit.
Risk of burns and scalds. Hot engine parts.
Always allow engine to cool down to ambient temperature before starting work.
To ensure correct functioning of the oil circuit and the forced flow lubrication,
BRP-Rotax
m WARNING
ATTENTION
sure in the by-pass valve.
Effectivity: 915 i A Series
Rev. 1