5000 Cp V6.0 Sp2 New Features And Enhancements; Dtmf Decoding Payload; Propagation Of Original Caller Id To P-Asserted Identity; Do Not Use Out-Bound Username In Register - Mitel MiVoice Office 250 Installation And Administration Manual

5000 CP v6.0 SP2 New Features and Enhancements

DTMF Decoding Payload

SIP Peers in Database Programming can be configured with the necessary custom payload type
value, depending on the supported payload type of the far end SIP provider. In previous releases,
this value was configured in IP Settings. In Release 6.0 SP2 and up, the DTMF Decoding Payload
is now located in the individual configurations for SIP Phone Groups, SIP Trunk Groups, and SIP
Voice Mails. The payload type is typically negotiated between carriers and devices, but in some
cases the SIP service provider does not accept requests. The DTMF Payload Type is made available
by the SIP trunk service provider.
Database Programming now allows the DTMF Payload type to be selected for SIP Peers, from a
range of values that correspond to those supported by the SIP service provider.
The default DTMF Decoding Payload value applies to North American, UK, and Australian systems.

Propagation of Original Caller ID to P-Asserted Identity

In Database Programming, a new flag, Do Not Propagate Original Caller ID to P-Asserted Identity,
was added. The administrator can set this flag when the Dynamic Extension Express (DEE) feature
is used, and a DEE destination is reached via a SIP trunk and the Propagate Original Caller ID flag
is enabled.

Do not use Out-bound Username in REGISTER

In Database Programming, a new flag, Do not use Out-bound Username in REGISTER, was added.
This flag controls the registration of a SIP call when upgrading to Release 6.0 SP2.
If the flag is set to No, the to/from/contact headers in the SIP register correspond to the out-bound
username. If the flag is set to Yes, the to/from/contact headers in SIP register correspond to the
trunk group Caller ID.

Support for new DDM16 and DEM16 circuit board revisions

New hardware revisions of the DDM16 and DEM16 circuit boards are fully supported by the Release
6.0 SP2 software.

MCD Interoperability Support

The Mitel 5000 Release 6.0 SP2 maintains all current support with the published MCD
Interoperability.

Microsoft Lync Integration Support

The Mitel 5000 Release 6.0 SP2 now has support for Microsoft Lync via the Micollab 6.0 product.
Refer to the MiCollab 6.0 documentation for details on this integration.
MiVoice Office 250 New Features
19