Example Cisco Configuration Commands; Private Network With Near-End Nat Traversal - Mitel MiVoice Office 250 Installation And Administration Manual

Example Cisco Configuration Commands

The following commands are provided as an example to further illustrate the recommended
configuration with respect to security. QoS configuration is beyond the scope of this appendix. These
configuration examples are based on the Cisco IOS Firewall feature set. Adtran
similar command set called AOS. For more information about Adtran routers Adtran Netvanta
Switch/Router on
guideline.

Private Network With Near-end NAT Traversal

The following diagram shows a configuration example.
The following commands set up the connection to the internal LAN. NAT is enabled, and it uses
access-group e0in
interface Ethernet0/0
description Internal LAN
ip address 192.168.1.1 255.255.255.0
ip access-group e0in in
ip nat inside
ip inspect inspector in
!
page 1-452. These commands are not intended to be complete; they are only a
for traffic coming in (to the router) from the internal LAN.
Network IP Topology
®
routers use a very
447