Eclipse EA500 Maintenance Manual page 261

(3) Make sure that the selected transponder is in Standby Mode.
(4) Push CODE soft key on left PFD and enter the transponder code used for this test or
1200.
C. Diversity Transponder-1 MODE A,C,S Test using Transponder Test Set, IFR6000 (Upper
Antenna)
(1) Power up the Transponder Test Set (IFR 6000). After tester performs Self Test, push
SETUP button on the test set to bring up the SETUP-XPDR page. If necessary,
continue pressing SETUP button until tester cycles to SETUP-XPDR page.
(2) On the Transponder Test Set (IFR 6000)'s SETUP-XPDR page, use NEXT PARAM
or PREV PARAM soft keys to select each parameter, and the "arrow" DATA keys to
set the values listed below.
• ANTENNA: TOP
• RF PORT: ANTENNA
• ANT RANGE-TOP: 18 ft.
• ANT HEIGHT-TOP: 7 ft.
• ANT RANGE-BOTTOM: 18 ft.
• ANT HEIGHT-BOTTOM: 1 ft.
• DIR CABLE LOSS: Ignore
• ANT CABLE: 1 ft.
• ANT CABLE LOSS: As marked on blue cable (should be 0.1 dB)
• ANT GAIN (dBi) - 1.03 GHz: As marked on test set antenna
• ANT GAIN (dBi) - 1.09 GHz: As marked on test set antenna
• UUT ADDRESS: AUTO
• MANUAL AA: Ignore
• DIVERSITY TEST: ON
• PWR LIM: FAR 43
• CHECK CAP: YES
(3) Push XPDR button to go to the XPDR-AUTO TEST page.
(4) Push CONFIG soft key to display the XPDR-CONFIG SCREEN page.
(5) On the XPDR-CONFIG SCREEN, scroll to GENERIC MODE S using the UP/Down
DATA keys.
(6) With GENERIC MODE S highlighted, push RETURN soft key to confirm selection.
This will also cause a return to the XPDR-AUTO TEST page.
(7) Set the WOW Box Switches to W-off-W (airborne).
(8) Push RUN TEST soft key to start AUTO TEST. The tester will sequence through
separate tests, after which a "PASS" message should be displayed.
EFFECTIVITY: NOTED
EA500 Aircraft Maintenance Manual — 06-117751
© 2020 Eclipse Aerospace, Inc.
Temporary Revision No. 34-21
34-50-20
CONFIG C
Page 527
Sep 30/20