(16) Press IDNT key on the Pilot's keyboard.
• IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(17) Press IDNT key on the Copilot's keyboard (If Installed).
• IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(18) Press IDNT button on the Pilot's Stick Grip.
• IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(19) Press IDENT button on the Copilot's Stick Grip.
• IDENT is displayed on Transponder Test Set, IFR6000.
NOTE: IDENT disappears from the IFR test set in approximately 20 seconds.
(20) Press STOP TEST button on Transponder Test Set, IFR6000.
D. Transponder-2 MODE A,C,S Test using Transponder Test Set, IFR6000
(1) Relocate to Antenna Coupler to Transponder 2 Antenna located in the Center Belly.
(2) Power Up: Press the POWER Key to power the Test Set.
(3) Press SETUP Control Key to display setup screens. Continue pressing SETUP
Control Key to cycle to SETUPXPDR Screen. Use NEXT PARAM and PREV PARAM
Soft Keys to select each parameter.
(4) Select RF PORT: Select DIR W/COUPLER
(a) Select CPL CABLE LOSS: Set to loss found on cable.
(b) Select COUPLER LOSS: Set to loss found on coupler.
(5) On left PFD use lower right softkey to scroll to XPDR, press ACTIVE softkey (upper
right button) on the left PFD to select XPDR2.
(6) Press MODE softkey button on the Left PFD to select ON
(7) Press XPDR button to go to the XPDR AUTO TEST page.
(8) Press CONFIG button. On the CONFIG line, scroll to GENERIC MODE S using the
up/down buttons and press the Return button and select RUN TEST, found on
display screen.
• Bottom ERP dBm should be between 48 to 60 and MTL dBm should be between
-67 to -79 to PASS.
(9) If values are obtained and test FAILS, press TEST LIST button on IFR 6000 and
using the up/down buttons, scroll to the specific failed test. Press SELECT TEST
button, adjust IFR antenna and press RUN TEST button until PASS message
appears
NOTE: This may take several adjustments until IFR 6000 and aircraft Transponder
SYNC UP.
EFFECTIVITY: 0001-0104, 0113-0115, 0120, 0123-0124
PRE SB 500-99-002 AND SB 500-99-005
EA500 Aircraft Maintenance Manual — 06-117751
© 2020 Eclipse Aerospace, Inc.
Temporary Revision No. 34-21
34-50-20
CONFIG A
Page 506
Sep 30/20
Need help?
Do you have a question about the EA500 and is the answer not in the manual?