Driver Seat Belt - PREVOST H3-45 VIP Owner's Manual

Fore-and-aft/Up-Down (2)
Push switch towards dashboard to move seat
forwards or back to move seat backwards. Pull
switch up to raise seat or push switch down to
lower seat
FIGURE 3: SEAT CONTROLS
Tilt (front) (3)
Pull switch up to raise front section of seat. Push
switch down to lower front section of seat.

DRIVER SEAT BELT

The driver's seat is equipped with a retractable
safety belt as required by State, Provincial and
Federal regulations.
WARNING
A snug fit with the lap belt positioned low on the
hips is necessary to maximize driver safety. The
belt should not be worn twisted. Avoid pinching
belt and/or belt hardware in seat mechanism. Do
not wear belt over rigid or breakable objects,
such as eyeglasses, pens or keys as these may
cause injuries.
CAUTION
Never bleach or dry clean safety belt.
To fasten, pull seat belt out of the retractor and
insert the latch plate into the buckle until it clicks.
No special adjustment is required since the reel
device is self-adjusting. If seat belt operation
becomes defective, report to a Prevost Car
service center immediately.
FIGURE 4: TO FASTEN SEATBELT
To unfasten belt, press the red button in center of
buckle and allow belt to retract. If the belt does not
fully retract, pull it out and check for kinks or
twists. Make sure that it remains untwisted as it
retracts.
FIGURE 5: TO UNFASTEN SEATBELT
Most State and Provincial laws require that
safety belts be worn when they are supplied with
the seat.
NOTE
The safety belt must be pulled out slowly and
continuously, otherwise it will lock the reel before
the latch plate reaches the buckle. If this happens,
allow the belt to retract completely and repeat the
procedure correctly.
PA-1619 Owner's Manual H3-45 VIP
Coach Interior 3-3
WARNING