PREVOST H3-45 VIP Owner's Manual page 157

FIGURE 6: PNEUMATIC CONTROL PANEL
NOTE
Refer to the slide-out decal for correct direction of
rotation (clockwise or counter clockwise).
3. To move the slide-out, use a cordless power
drill with a 3/8" hexagonal bit on the shaft
extension of the slide-out motor.
4. Rotate the slide- out motor shaft extension
with the power drill until the slide-out comes
to its closed position.
5. Once the slide- out room is lined up to its
closed position, remove the tool from the
motor.
NOTE
The front slide-out motor is located inside the 2nd
baggage compartment while the rear slide- out
motor is accessible from inside the vehicle, under
the bed structure.
FIGURE 7: SLIDE-OUT MOTOR MANUAL ACTIVATION
Slow down on the closing speed as the slide-out
approaches its closed position. As soon as the "in
limit" stoppers come in contact with their bearing
surface, stop immediately the power drill rotating
movement. Not doing so could overload the drive
mechanism and cause damage to the reduction
gearbox.
6. Finally, the inflatable seal can be re-inflated
FIGURE 8: INFLATABLE SEAL PRESSURE GAGE
NOTE
The slide-out control system inhibits transmission
range selection to prevent the vehicle from moving
if the slide-out is not in its full "IN" position.
PA-1619 Owner's Manual H3-45 VIP
Other Features 5-35
CAUTION
by turning the shut- off
counterclockwise. Check the pressure gage
on the inflatable seal regulator to see if the
pressure is increasing to around 15 psi.
Needle should point between the green
indicator pegs.
valve handle