Windshield; Fluid Level Verification; Engine Oil Level - PREVOST H3-45 VIP Owner's Manual

Before washing the exterior of the vehicle, close
the fresh air dampers using the "REC" button
located on HVAC control panel and on the air
intake duct in the evaporator compartment. Install
keyhole protectors to
penetrating. Rinse vehicle with water to remove
all loose dirt. Wash vehicle using quality brand car
wash soap. Follow
recommendations for cleaning. Rinse well with
water.
The vehicle exterior should be cleaned, waxed and
buffed when water droplets no longer form on the
painted surfaces.
CAUTION
Hot water can damage paint. Keep water cool or
lukewarm.
CAUTION
Make sure cleaning solutions are not harmful to
painted surfaces. Read
instructions before using.
CAUTION
Do not spray water jet directly into fresh air inlet
dampers.
CAUTION
Do not aim high pressure water jet at radiator or
condenser doors. This could damage the fins.
To prevent corrosion, remove caked-on dirt and
road salt from the vehicle underbody using a high
pressure water jet. Clean wheel housings,
bumpers, muffler, tailpipe and brackets.
Carry out corrosion prevention cleaning at least
twice a year. Spray underneath of the vehicle and
let soak before cleaning. Let engine and exhaust
system cool down before cleaning.
Tar Or Oil
Remove tar or oil as soon as possible with an
approved automotive tar and oil remover or
turpentine. Thoroughly clean area with car wash
soap and water. Let dry, then wax.
Insects
Remove insect stains as soon as possible with
lukewarm soap and water or insect remover.
prevent water from
manufacturer's
the manufacturer's
PA-1619 Owner's Manual H3-45 VIP
Care and Maintenance 8-5
Tree Sap
Remove tree sap or bird droppings with lukewarm
soap and water. Do not allow to harden.

WINDSHIELD

To prevent windshield wiper streaking, keep
silicone sprays away from windshield. Remove
road film and wax build- up from windows with
lukewarm soap and water or with an alcohol-based
cleaning agent. If a chamois is used to dry and
polish glass, use it exclusively for that purpose.
Wiper Blades
To avoid tearing frozen wiper blades, loosen them
before removing. Remove and clean wiper blades
periodically with an alcohol- based cleaning
solution. Clean wiper blades using a sponge or
soft cloth.

FLUID LEVEL VERIFICATION

Periodic inspection of oil and fluids levels is the
most economical and easiest way to help your
vehicle perform at its best. Rigorous oil level
inspection and replacement will greatly help
minimize expensive and unscheduled repairs.

ENGINE OIL LEVEL

WARNING
Check the engine oil level with vehicle parked on a
level surface and with the parking brake engaged.
Check engine oil level when engine is still warm.
Shut off engine and wait at least 10 minutes for oil
to drain into oil pan before checking. Check engine
oil level daily or before each trip. Add oil as
required. Do not overfill. Remove dipstick, wipe
clean and fully reinsert to ensure an accurate
reading. Remove dipstick and check engine oil
level.
Do not let the oil level fall below the marking on
the dipstick. Do not overfill so the level is above
the upper marking on the dipstick. Add oil through
the oil filler pipe as required in order to maintain
level within the safe range.