Driver Seat Belt - PREVOST X3-45 Commuter 2020 Operating Manual

FIGURE 3: DRIVER'S SEAT ADJUSTMENT (RECARO)
Fore and Aft
To adjust distance between driver
and dashboard, pull handle (1) up
and slide the seat forward or
backward. Release handle to lock
the seat in position.
Backrest
Turn hand wheel recline (2) to
adjust backrest to the desired
angle.
Up and Down
Toggle up/down switch (3) to
adjust the height of the seat.
DOB 1300-1556
Fore and Aft Auto
Actuator
To adjust distance
between driver and
dashboard, push auto
actuator (4) and slide
the seat forward or
backward. Release
button to lock the seat
in position.
PA-1639 Operator's Manual 2020 X3-45 Commuter
Lumbar Support
Use the 3-cell lumbar switches (5)
to adjust lumbar support.

DRIVER SEAT BELT

The driver's seat is equipped with a retractable
safety belt as required by State, Provincial and
Federal regulations.
WARNING
A snug fit with the lap belt positioned low on the
hips is necessary to maximize driver safety.
The belt should not be worn twisted. Avoid
pinching belt and/or belt hardware in seat
mechanism. Do not wear belt over rigid or
breakable objects, such as eyeglasses, pens or
keys as these may cause injuries.
CAUTION
Never bleach or dry clean safety belt.
To fasten, pull seat belt out of the retractor and
insert the latch plate into the buckle until it clicks.
No special adjustment is required since the reel
device is self-adjusting. If seat belt operation
becomes defective, report to a Prevost Car
service center immediately.
FIGURE 4: TO FASTEN SEATBELT
To unfasten belt, press the red button in center of
buckle and allow belt to retract. If the belt does
not fully retract, pull it out and check for kinks or
Coach Interior 3-3