Plastic And Vinyl; Windows; Stainless Steel; High Pressure Laminate - PREVOST H3-45 VIP Owner's Manual

8-4 Care and Maintenance
Marking Ink (Felt-tip Pens)
Treat with Methyl Ethyl Ketone (MEK) followed by
method two.
Oil, Grease And Paint
Remove excess using a knife. Treat with method
one followed by method two. If stain persists,
repeat procedure.
Rust Stains
Remove rust stains by following method two.
Apply a warm oxalic acid solution to stained area.
Rinse with water.
Tar
Soften tar with mineral spirits, then treat using
method one followed by method two.
Chewing Gum
Soften gum with cyclohexane. Carefully scrape off
stains using a sharp knife or razor blade.

PLASTIC AND VINYL

Clean plastic and vinyl trim using a clean damp
cloth or sponge. For vinyl trim marks, use a
lukewarm all- purpose cleaner or a mild saddle
soap. Remove water spots and soap traces using
a clean damp cloth or sponge. Dry with a clean
soft cloth.
Remove grease, tar or oil stains with a clean cloth
or sponge and an all-purpose or solvent-type vinyl
cleaner.
Apply a colorless vinyl or leather protective
product to maintain the luster and pliability of the
plastic or vinyl surface.

WINDOWS

Clean the inside of the windows with a solution of
one part vinegar to ten parts water.

STAINLESS STEEL

Use a stainless steel cleaner and follow the
manufacturer's instructions.
cleaning solution may be ordered from Prevost
quoting part number 680356.
Stainless steel
PA-1619 Owner's Manual H3-45 VIP

HIGH PRESSURE LAMINATE

Remove stains on laminated surfaces (Formica)
with a household detergent, methylated spirits or
mineral spirits. Clean with a mild liquid abrasive
and water solution if stain persists.

RUBBER COMPONENTS

Use only pure water or glycerin to clean stains on

rubber components.

CAUTION
Never use solvents on rubber components.

FLOOR CLEANING

To keep its original appearance, wash the floor
regularly. Clean vinyl floors with a quality nonionic
detergent cleaner or a household all- purpose
cleaner. Follow
recommendations for cleaning.
Remove any excess detergent solution using a
wet/dry vacuum or mop. Rinse floor with a solution
of one part Clorox to ten parts warm water.
Polish dry floor using a high-speed buffer and a
smooth red 3-M polishing pad.
Mop floor periodically with a solution of 5 percent
Clorox in warm water.
NOTE
For custom or special floor covering materials,
consult the manufacturer or your converter for
information on how to clean and maintain these
types of floors.
CAUTION
Using a water hose to clean the floor is prohibited
since it could cause electrical shorts or damage
the electrical system.

EXTERIOR SURFACES

Frequent washing and waxing of the vehicle
exterior will help protect the finish and luster. The
paint finish is attacked by the abrasive effects of
airborne particles and corrosive pollutants.
the manufacturer's