7-10 Safety Features and Equipment
debris from being thrown at vehicles traveling
behind the vehicle.
Splash guards may be installed behind each dual
wheel of the drive axle to prevent stone projectiles
from being thrown at the tag axle wheels.
BACK-UP CAMERA
An optional back- up camera is available which
provides the driver with visual assistance when
backing-up. The monitor is mounted on the left
side pillar. It switches on automatically when the
transmission is in the reverse (R) range.
BACK-UP ALARM
The back-up alarm alerts pedestrians and other
drivers when the vehicle is being backed-up. Take
extra precautions
whenever backing- up.
necessary, use a guide to provide directions when
backing-up. The back-up alarm is automatically
activated when the transmission is put into
reverse gear (R) .
BACK-UP ALARM CANCEL SWITCH
A rocker switch located on the lateral control panel
allows the driver to cancel the back- up alarm
system (as for example: at night on a camping
site).
NOTE
After use, return to normal operation.
ESSENTIAL FUNCTIONS TO OPERATE
THE VEHICLE (BASIC LIMP-HOME
FUNCTIONS)
Even with a defective CECM (Chassis Electronic
Control Module) or a CAN network problem,
essential base functions are maintained to rear
start the vehicle from the engine compartment and
drive in a secure manner.
AVAILABLE FUNCTIONS
Startup: Turn on the ignition in the driver's
l
area and rear start the vehicle from the engine
compartment,
Opening the door: Functions normally,
l
The following directives must be followed.
If
PA-1619 Owner's Manual H3-45 VIP
Closing the door: Manually pull on the door
l
and it will lock automatically,
Windshield wipers: Wipers functions at 1st
l
speed only
Windshiels washer fluid: Lower windshield
l
washer
Headlights: Low beams only,
l
Directional signals: Rear and front only,
l
Stoplights: 2 upper stoplights + high-mounted
l
stoplight are functional,
HVAC: Functional with set point fixed at 70°F
l
(22°C), evaporator and condenser fixed at
speed 1, defroster fixed at speed 4.
CAUTION
Never connect a battery charger when the
l
ignition is at the ON position on a vehicle
with a defective CAN or certain functions
will start up by themselves,
Disconnect the charger before starting the
l
vehicle, if not the default functions will not
activate,
If the default mode does not activate, try
l
to turn the ignition OFF while ensuring that
no charger is connected and then restart
the vehicle.