Slide-Out Troubleshooting Table - PREVOST H3-45 VIP Owner's Manual

SLIDE-OUT TROUBLESHOOTING TABLE

PROBLEM
The slide- out functions
normally but the control pad
green indicator light blinks.
FLUSH FLOOR S/O ONLY
Problem: The slide-out stops
extending/retracting and the
green indicator light flashes
rapidly 3 times then one long
flash (cycle repeats).
FLUSH FLOOR S/O ONLY
Problem: Slide out does not
extend/retract.
FLUSH FLOOR S/O ONLY
Problem: The slide- out
does not extend/retract.
FLUSH FLOOR S/O ONLY
Problem: Motor stopping
temporarily during
extend/retract sequence.
CAUSE
Something is defective and
may eventually create an
issue if not repaired. The
problem may be:
A. Faulty limit sensor causing
the slide- out to stop in
overcurrent;
B. CAN network problem
causing the transmission
inhibit safety to be non-
operational;
C. Vacuum pressure
transducer disconnected or
damaged (vacuum is applied
for a fixed time of 7 seconds);
D. Seal inflating
solenoid open circuit (the seal
is not re- inflated and water
can penetrate in the vehicle);
E. Security pin valve solenoid
open circuit (the security pin
is not extended while vehicle
is riding).
At least one of the mobile floor
position switches is defective
and the system
operator's input to resume
normal operation. The floor
might also be out of level.
The slide out stopped moving
due to an obstruction.
At least one of the motors is
defective.
The slide out motors goes out of
synchronization.
PA-1619 Owner's Manual H3-45 VIP
CORRECTIVE ACTION
Using the Driver Information Display (DID),
request a diagnostic of the electrical system.
valve
Depress the handheld control in the desired
requires direction 3 times rapidly and hold it the fourth
time until the slide out has reached the desired
position.
Clear the path of the S/O and /or mechanism
and resume operation.
Refer to manual override procedure.
Make sure that load is distributed evenly
across the
wear/obstructions in the slide out mechanism.
Other Features 5-39
slide out. Check for