Vehicle Messages; Reset Trip Data; Display Settings - PREVOST H3-45 VIP Owner's Manual

VEHICLE MESSAGES

Use this function to consult the vehicle active messages that were previously displayed as pop-up messages
and then acknowledged. When consulting a message, the corresponding STOP, CHECK or INFORMATION
warning light will illuminate. Scroll through the messages using the up/down button. Press ESC button to return
to main menu.

RESET TRIP DATA

DISPLAY SETTINGS

The Display Settings menu is used to change languages and units. The password, time and date can also be
changed. The backlight and contrast of the display screen can be adjusted.
4. Average Trip Speed
This function displays the average speed for the current travel. The average trip
speed is calculated as the distance traveled divided by the time the engine has
been running (since the last reset). Two average trip speeds can be measured,
corresponding to leg 1 and leg 2. Use Reset function before each new travel to
start new measurements.
5. Estimated Time of Arrival (ETA)
This function will display the estimated time of arrival if the distance to be
traveled is entered first, in this menu. To set distance to be traveled, press
ENTER and enter the distance left to drive in mile or km using ENTER and
UP/DOWN buttons.
When the Reset Trip Data menu is open, pressing and holding down the Enter
button for 1 second resets the functions listed below. This function will permit
to the system to calculate new value from the point of resetting.
Fuel flow
l
Trip Fuel Used
l
Average Trip Speed
l
1. Language
PA-1619 Owner's Manual H3-45 VIP
Other Features 5-15