Windshield Defogger; Panel And Footwell; Panel; Temperature Degree Selector - PREVOST X3-45 COACH 2018 Operator's Manual

Controls and Instruments
4-28
(0°C), the compressor will keep running up to
a temperature of 15°F (-9°C) to prevent
condensation from forming on the windows.

Windshield Defogger

Upon pressing
dashboard damper sends air only to
the lower windshield. The fan is
turned on to maximum speed, the
fresh air damper opens completely
(REC off) and the driver set point is
22305
increased to 4°F (2°C) over the
passenger's section set point.
The dashboard damper sends air only
to the lower
activated. The footwell damper is
closed also but the fan speed can be
22139
reduced or increased.

Panel and Footwell

The dashboard damper sends air to
the panel vents and footwell.
22137

Panel

Air is sent to panel registers. The
footwell damper is closed.
22136

Temperature Degree Selector

Toggles the
temperature units between Fahrenheit
and Celsius. The driver's section must
be on. Also toggles the outside
temperature units displayed on the
22133
telltale panel.
AUDIO-VIDEO SELECTOR
PASSENGER'S AREA
The VSS-05 Video and Sound Selector enables
the driver to select audio, audio/video and video
source with settings of volume level, bass,
treble, etc. for the passenger's area only. The
this button, the
windshield when
HVAV control unit
FOR THE
PA1627 X3-45 Operator's Manual
DVD player, TV tuner, P.A. system and auxiliary
audio or video sources are controlled with this
unit.
TURNING POWER ON AND OFF
Press button to turn on the unit.
Press button again to turn off the unit.
SETTING OF VOLUME/ BASS/ TREBLE/
BALANCE/ LOUDNESS
Press audio button repeatedly to
choose the desired mode. Each
press changes the modes as
follows:
Turn volume knob until the desired sound is
obtained in each mode. The final setting will
apply to all audio sources for the passenger's
area. If no button is pressed within 8 seconds
after selecting BASS, TREB, BAL and LOUD
modes, the unit automatically sets in the VOL
mode. The volume value adjust from 0
(complete mute) to 40 (maximum).
SELECTION OF AUDIO OR AUDIO/VIDEO
SOURCE
Press RADIO/CD button to select
the dashboard radio as current
audio source for the passenger's
area. Pressing this button will also
permit to listen to the CD inserted in
the dashboard radio.
Press AUDIO IN button to select an
auxiliary audio input as current
audio source. AUDIO IN RCA
connections are located at the back
of the VSS-05 unit.
Press DVD button to select the in
dash DVD
audio/video source.
If an optional TV tuner is installed,
press TV button to select it as
current audio/video source.
Press VIDEO IN button to select an
auxiliary video input as current
audio/video source.
player as current