Table of Contents
Advertisement
Processing a Signal
Access processing view by clicking an input / output button or a filtering tool in the DSP
session view. Use processing view to configure the selected audio signal.
Different port types have different processing modules.
In general:
•
Toggle the
The module is enabled while it is set to On and disabled when set to Off.
•
In the processing view, the module appears at the center and input/output volume sliders
appear to the left/right (for further information, see
on page 25).
•
Adjust configuration knob by clicking and holding the mouse then moving it up or down,
or enter the parameter value below the knob and press Enter on your keyboard to apply.
•
Reset a configuration knob to its default parameter value, by clicking the mouse within
the knob area while pressing Ctrl on your keyboard.
•
The parameter value always appears below the knob or slider.
•
A selected input or output button appears with a white rim.
•
A selected processing tool button appears with a distinctive color.
•
An enabled processing tool button appears with a distinctively colored rim.
Processing modules enable performing the following functions:
•
Adjusting Analog Input Parameters
•
Adjusting Digital Input
•
Post-Matrix Signal Processing
•
Using Expander Module
•
Using HPF (High Pass Filter) Module
•
Using AFS (Auto Feedback Suppression) Module
•
Using Compression Module
•
Using Equalizer Module
•
Using Gain Module
•
Using Post Matrix Equalizer Module
•
Using LPF (Low Pass Filter)
•
Using Limit Module
AFM-20DSP – Processing Audio Signals
(off) /
(on) button to enable/disable a processing module.
on page 26.
Parameters on page 27.
on page 34.
on page 27.
on page 31.
on page 32.
on page 33.
on page 35.
on page 36.
Input / Output Channels Operation
on page 28.
on page 30.
on page 35.
Kramer Electronics Ltd.
24
Advertisement
Table of Contents
