3. If DHCP is set to Off, change any of the parameters (IP Address, Mask and/or Gateway).
4. If required, change the TCP port number.
5. Click Save. the following message appears.
Figure 65: Communication Settings Tab – Communication Error Message
After changing the IP address, reload the webpage with the new IP address.
If DHCP is On, reload the webpage with the new IP address (see below).
Ethernet settings have changed.
Setting Parameters when DHCP is On
To set parameters when DHCP is set to On:
1. In the Navigation pane, click Settings. The General tab in the Settings page appears.
2. Select the Communication tab.
3. Take note of the Device Name in the General tab (you will need it when reloading the
page).
4. Set DHCP to ON.
5. Click Save.
6. Type the device name in the address bar of your browser to reload the page.
You can read the new IP address from the Communication Settings page.
Parameters are set.
AFM-20DSP – Defining Settings
Kramer Electronics Ltd.
53