Post-Matrix Signal Processing
AFM-20DSP
enables performing post-matrix signal processing to outputs, including:
•
Using Delay Module
•
Using HPF (High Pass Filter) Module
•
Using Post Matrix Equalizer
•
Using LPF (Low Pass Filter)
•
Using Limit Module
Setting Audio Output Parameters
Analog, Dante, HDMI and S/PDIF output signal settings are identical. Dante is used as an
example in this section.
See
Input / Output Channels Operation
To adjust the audio outputs:
1. In the Navigation pane, click DSP. The DSP (Main) page appears.
2. Click Dante.
The Dante processing page appears.
3. Perform the following actions:
▪
Move the volume fader to set the output audio level (both sliders are identical).
▪
Toggle
▪
Click
Audio outputs are adjusted.
AFM-20DSP – Processing Audio Signals
on page 33.
Moduleon page 35.
on page 35.
on page 36.
Figure 37: Processing View – Processing Digital Input
/
to mute / unmute the output audio, respectively.
to inverse polarity (used for troubleshooting).
on page 28.
on page
25
to understand the function of the slider.
Kramer Electronics Ltd.
34