Table of Contents
Advertisement
Pre-Matrix Signal Processing
This section describes the input pre-matrix signal processing of the input audio signal. The
input fader always appears to the left.
Adjusting Analog Input Parameters
See
Input / Output Channels Operation
IN 1 is used as an example in this section.
To adjust analog input parameters:
1. In the Navigation pane, click DSP. The DSP (Main) page appears.
2. Click IN 1.
The IN 1 processing page appears.
3. Perform the following actions:
▪
Move the fader to adjust the audio input level.
▪
Select Pre or Post to set the signal volume before and after using the pre-matrix
modules.
▪
Toggle
▪
Click
▪
Click
▪
Click
title IN changes to MIC).
Analog input parameters are adjusted.
AFM-20DSP – Processing Audio Signals
Figure 26: Processing View – Processing Analog Audio Input
/
to mute / unmute the input audio, respectively.
to inverse polarity (used for troubleshooting).
to select audio line in.
to select dynamic microphone and
on page
25
to understand the function of the slider.
to select condenser microphone (the
Kramer Electronics Ltd.
26
Advertisement
Table of Contents
