6. Select Use the following IP Address for static IP addressing and fill in the details as
shown in
Figure
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255
(excluding 192.168.1.39) that is provided by your IT department.
7. Click OK.
8. Click Close.
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the
or using a straight-through cable with RJ-45 connectors.
Configuring the Ethernet Port
You can set the Ethernet parameters via the embedded webpages.
AFM-20DSP – Operating and Controlling AFM-20DSP/AFM-20DSP-LE
Figure 9: Internet Protocol Version 6 Properties Window
10.
Figure 10: Internet Protocol Properties Window
AFM-20DSP
to the Ethernet port on a network hub
Kramer Electronics Ltd.
14