Table of Contents
Advertisement
3. Set the following:
▪
Select Pre or Post to set the signal volume before and after using the modules.
▪
Toggle
▪
Click
For analog audio inputs only:
▪
Click
▪
Click
title changes from IN to MIC).
Audio parameters are defined.
Defining Snapshots
Store a snapshot (inputs, outputs and amplifier) to store the current configuration state, recall
a snapshot, set to default or clear a snapshot.
Storing Snapshots
To store a snapshot:
1. In the Navigation pane, click Mixer. The Mixer page appears.
2. Set input and output mixers.
AFM-20DSP – Processing Audio Signals
/
to mute / unmute the input audio, respectively.
to inverse polarity (used for troubleshooting).
to select audio line in.
to select dynamic microphone and
Figure 49: Mixer Page – Analog Audio Settings
Kramer Electronics Ltd.
to select condenser microphone (the
42
Advertisement
Table of Contents
