Table of Contents
Advertisement
4. Set the following:
▪
Threshold – T
begin working. If a signal is too low or does not cross the threshold, the compressor allows
the signal to pass through unchanged.
▪
Attack Time – The response speed of the compression to signal levels above the
threshold.
▪
Release – The response speed of the compressor to signal levels above the
threshold.
5. Open the Ratio drop-down box to set the extent to which the gain is decreased.
6. Set the gain to compensate for the attenuation caused by compression.
The Comp settings are adjusted.
Using Equalizer Module
Use the Equalizer module to change the balance of different frequency components in the
audio signal.
To adjust the equalizer:
1. In the Navigation pane, click DSP. The DSP (Main) page appears.
2. Click EQ.
The button turns orange and the Equalizer processing page appears.
3. Click the Off button
4. Perform the following actions for each of the 4 bands:
▪
Click BYPASS to ignore a band.
▪
Adjust the band Frequency (Hz).
▪
Set Bandwidth (Oct) to set the range of frequencies around the selected frequency.
▪
Set the bandwidth audio Level (dB).
Equalizer settings are adjusted.
AFM-20DSP – Processing Audio Signals
he level that the signal needs to rise above in order for the compressor to
. The Equalizer module turns on
Figure 34: Processing View – Equalizer Module
Kramer Electronics Ltd.
.
32
Advertisement
Table of Contents
