Operation; Before Commencing Spray Job; Set Up Before Spray Job - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

Before Commencing Spray Job

Set Up Before Spray Job

÷
NOTE! This is only used when spraying without AutoSectionControl or any other field management system.
The following steps is to be taken to set up the sprayer before beginning a spray job.
1. Set the volume rate for the present spray job.
See "Volume Rate" on page 85.
2. Select the nozzle type to be used, depending on whether
normal spraying or fertilizer spraying is being used.
3. Adjust specific gravity when changing between a normal
spray job and fertilizer spraying.

5 - Operation

V o l u m e r a t e
l i t r e / h a
U s e a r r o w k e y s o r n u m e r i c k e y s
t o s e t t h e d e s i r e d v o l u m e
r a t e
T y p e o f n o z z l e
M e n u
R e g u l a r n o z z l e
Q u i n t a s t r e a m
F l a t f a n , L o w d r i f t , M i n i d r i f t
A d j u s t m e n t o f s p e c i f i c g r a v i t y
K g / l i t r e
E n t e r w e i g h t o f l i q u i d
f e r t i l i z e r d i v i d e d b y w e i g h t
o f w a t e r ( e . g . 1 . 1 0 t o 1 . 3 0 )
83