Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book page 125

ID Type Fault Text at Display
(PG)
136 Warning Lift the boom
137 Warning Boom not in transport
139 Alarm Dynamic centre sensor
140 Alarm Pendulum unlock sensor
141 Warning Reg Valve sensor fault
142 Warning Boom flow sensor fault
143 Warning Boom press sensor fault
144 Warning Main pump RPM sensor fault
145 Warning Reg valve motor fault
146 Warning Agitation sensor fault
147 Warning Agitation motor fault
148 Warning Hydraulic valve calib error
150 Warning PF motor blocked #
151 Warning PF motor short #
152 Warning PF motor disconnect #
153 Reminder AutoWash completed cycle #
154 Alarm FastFiller valve motor fault
155 Alarm FastFiller valve sensor fault
156 Alarm Pressure valve motor fault
157 Alarm Pressure valve sensor fault
158 Alarm Suction valve motor fault
159 Alarm Suction valve sensor fault
160 Alarm Illegal AutoWash Setup
161 Warning Pump RPM too low Increase
162 Warning Pump RPM too high Decrease
163 Warning Increase pump flow
164 Warning Increase pump flow
Criteria for Fault
Operations Disabled
When TWIN FORCE, TERRA FORCE or DELTA
FORCE boom hydraulics set-up has been
selected.
The boom lift is in a too low position, to
ensure proper function of the transport lock.
PTO rev. too low (limit set in menu).
PTO rev. too high (limit set in menu).
7 - Fault Finding
Help Text
The boom lift is in a too low position, to
ensure proper function of the transport lock.
Increase PTO speed
Decrease PTO speed
125