Page 1
EAGLE (SPB / SPC) BOOM INCLUDES Operator’s Manual PARALIFT 67022304 - AU - 03/03...
Page 2
March 2003 edition Illustrations, technical information and data are to the best knowledge of HARDI AUSTRALIA Pty Ltd, correct at the time of printing. Published by HARDI AUSTRALIA Pty Ltd HARDI AUSTRALIA Pty Ltd reserves the right to make...
It is equally important that other operators of this equipment read and The HARDI EAGLE SPB / SPC boom is for use on a understand this manual. HARDI sprayer - for the application of plant protection and liquid fertiliser chemicals.
EAGLE (SPB / SPC) BOOM Description Glossary The extra heavy duty, self-levelling HARDI EAGLE Right hand / Left hand sides boom range consists of the following sizes and models: Are determined by facing the forward direction of travel. Folded boom 18 and 20m SPB EAGLE booms: Refers to the boom in transport position.
12 volt attachments. IMPORTANT! Ensure hydraulic lines have not NOTE! Check with your HARDI dealer or your been damaged during shipping. tractor’s operator’s manual for the best location to Be sure to hook up hydraulic lines properly! hook up the 12 volt system.
Transport Brackets Height Setting Suspension (SPC only) The SPC boom features adjustable suspension for Hardi Commander and Explorer sprayer transport brackets can be set in different positions to obtain 24-28 m booms and 30 m booms. different transport heights and suitable clearance above The spring A has two assembly positions as shown on various tractor cabins.
EAGLE (SPB / SPC) BOOM Boom folding / unfolding (XY - Manual Fold model) 1 Raise the boom to release it from transport supports. Operation 2 Manually unfold each wing separately until the mechanical lock on the wing is engaged CAUTION! Always operate boom on level ground.
HARDI sprayer that does not have an operator’s manual, individual paragraphs regarding maintenance jobs or if you have a HARDI EAGLE boom fitted to a non before starting the job. If any portion remains HARDI sprayer and you don’t have any manuals,...
EAGLE (SPB / SPC) BOOM NOTE! Grease on the centre frame wear pads should be completely removed with a degreasing solvent and replaced every 50 hours. Lubrication Boom Centre / Intermediate wing pivot points Recommended lubrication schedule for your Eagle Grease the points indicated in Fig 11.
EAGLE (SPB / SPC) BOOM SPC boom breakaway 25 Hours Chain and sprocket Oil the entire length of the chain and all of the sprocket. Grease sprocket shafts only where indicated in Fig 13 Grease Fig 15 SPB boom breakaway Fig 13 50 Hours Gantry and centre frame...
EAGLE (SPB / SPC) BOOM Aligning wing assemblies 1 With the boom unfolded and in the working position, Adjustments check alignment of the intermediate section with the centre frame. WARNING! Do not allow anyone under the 2 With the fold cylinder pressurised, determine if the boom while adjustments are taking place.
EAGLE (SPB / SPC) BOOM Aligning centre and intermediate sections Aligning intermediate and outer sections 1 Unfold the boom and check alignment of the inner section with the centre section. 2 If adjustment is necessary, relieve pressure from the cylinder by folding the boom a few centimetres. 3 Disconnect cylinder rod eye (A Fig 22) from the inner section.
EAGLE (SPB / SPC) BOOM Adjusting front fold cable Adjusting wings level to ground SPB 18-20 XY (Hydraulic Fold) boom WARNING! The rear cable can snap and injure you or someone else if tensioned when the boom 1 Loosen the lock nut (A Fig 28). is unfolded.
EAGLE (SPB / SPC) BOOM Aligning breakaway section with intermediate Adjusting break-away clutch boom section (SPC) SPB boom 1 Slightly loosen the two bolts / nuts at A (fig 28), just 1 Check that the lower nut (A Fig 30) is fully tightened. enough to allow movement.
EAGLE (SPB / SPC) BOOM Adjusting centre frame Adjusting centre frame cables This adjustment will affect the trapeze function and IMPORTANT! Never attempt to adjust the centre must therefore be done properly. frame cables without having the boom folded all the way into the transport position! IMPORTANT! Lubricate the pivot linkage and grease the skid plates prior to adjustment.
EAGLE (SPB / SPC) BOOM Adjusting the yaw dampers rubber (SPC only) Adjusting boom transport position Manual fold boom Boom yaw motion refers to the horizontal swinging 1 Fold the boom into the transport position. Deter- action of the boom wings around the upright pivot mine if the boom sections need to be adjusted points (Fig 37).
Disassemble, check condition and position of O-ring or gasket, clean, lubricate and reassemble. For radial connections, only hand tighten them. O-rings must be lubricated all the way around before re- fitting. HARDI recommends using a vegetable-based oil to prolong the life of O-rings. Fig 40 Fig 41...
HARDI sprayer that does not have an operator’s manual, 14 Chock up the wheels, to prevent moisture damage or if you have a HARDI EAGLE boom fitted to a non and deformation of the tyres. Tyre blacking can be HARDI sprayer and you don’t have any form of instruc- applied to the tyre walls to preserve the rubber.
EAGLE BOOM Troubleshooting In cases where breakdowns have occurred, the same factors always seem responsible. Usually hydrau- lic components that are contaminated with dirt result in rapid wear to the hydraulic system. Therefore always check hydraulic components are maintained, clean and free from leaks. Problem Probable cause Control / Solution...
Materials and recycling shown as one of a group of parts in a numbered kit. Hoses This number is the HARDI parts number for the part or Fittings kit of parts. When the equipment has completed its working life, it must be thoroughly cleaned.
Page 37
EAGLE (SPB / SPC) BOOM COMMANDER S 6000 Eagle Paralift 2 x 161382 4 x 43003204 4 x 460703 (nut) 637953 2 x 61014904 2 x 460143 (nut) 2 x 420567 (bolt) 638010 2 x 420825 2 x 16024504 4 x 430870 (bolt) 4 x 460703 (nut) Comm S Paralift cylinders: 2 x 61008904...
Need help?
Do you have a question about the EAGLE SPB BOOM and is the answer not in the manual?
Questions and answers