Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book page 123

ID Type Fault Text at Display
(PG)
32 Illegal action No rinse water
33 Warning Steering not active Over speed
34 Waiting Start FlexCapacity pump
35 Waiting Stop FlexCapacity pump
36 Waiting Pause
37 Warning PrimeFlow Comm. Fault
38 Warning Output failing to sect 1
39 Warning Output failing to sect 2
40 Warning Output failing to sect 3
41 Warning Output failing to sect 4
42 Warning Output failing to sect 5
43 Warning Output failing to sect 6
44 Warning Output failing to sect 7
45 Warning Output failing to sect 8
46 Warning Output failing to sect 9
47 Warning Output failing to sect 10
48 Warning Output failing to sect 11
49 Warning Output failing to sect 12
50 Warning Output failing to sect 13
51 Warning Output failing to bypass
52 Warning Nozzle valve air pressure too low
56 Warning Rinse tank not full
58 Warning Sections OFF
83 Reminder Aborted by Keypress
84 Warning AutoWash exception alarm #
88 Reminder Check filters & brakes
89 Reminder Grease points
90 Reminder Tighten bolts
91 Reminder Miscellaneous service
92 Reminder Check nozzles
94 Warning Rollover-protection activated
95 Changed Track is in auto
Criteria for Fault
Operations Disabled
When pressing soft key for either BoomFlush,
FastFlush, MultiRinse while RinseTank is
calculated too empty for that program.
Key press does not start process.
Used by AutoWash/AutoFill.
Valves are positioned as in AutoWash table.
After press on soft key computer continues to
next step.
See also screen layouts.
Used by AutoWash/AutoFill
Valves are positioned as in AutoWash table.
After press on soft key computer continues to
next step. See also screen layouts.
Used by AutoWash/AutoFill.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
Detected by H-bridge on I2C bus.
When MainTank has been filled and RinseTank is
empty.
7 - Fault Finding
Help Text
Not enough rinse water for selected program.
AutoWash cannot be started.
Double pump must be started to flush hoses.
Stop and start Double pump with hydraulic
lever, as Warning prompts you to.
Double pump must be stopped to avoid
chemical in boom.
Stop and start Double pump with hydraulic
lever, as Warning prompts you to.
Output failing to sect 1
Output failing to sect 2
Output failing to sect 3
Output failing to sect 4
Output failing to sect 5
Output failing to sect 6
Output failing to sect 7
Output failing to sect 8
Output failing to sect 9
Output failing to sect 10
Output failing to sect 11
Output failing to sect 12
Output failing to sect 13
Remember to re-fill rinse tank.
123