Menu 4 Toolbox; Menu 4.1 Service Intervals: Hours Until; Menu 4.2 Service Interval Reset - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

Menu 4 Toolbox

Menu 4.1 Service intervals: Hours until

Service intervals and a nozzle check are programmed into the
Controller. This makes it easier for the operator to remember the
service intervals.
From the factory, the Controller is set up with three service and a
nozzle check reminder.
Service Interval Action
10hrs Check filters reset See sprayer instruction book, Maintenance.
50hrs Grease boom reset See sprayer instruction book, Maintenance.
250hrs Grease track and centre See sprayer instruction book, Maintenance.
Miscellaneous service Not defined from factory.
10hrs Check nozzles Check flow rate. Change nozzles if more than 10%
of rated flow.
Entering the above menu's will display the hours remaining until next service. The importer or dealer may have added a
"Miscellaneous service" interval. If no interval is set, [Miscellaneous service not defined] is shown.
Press to register service or control, if displayed when switched on. The reminder
service interval is reset.

Menu 4.2 Service interval reset

To reset service interval, go to relevant interval menu and:
• Press
to reset hour meter.
• Press
to leave unchanged.
3 - Description
S e r v i c e i n t e r v a l : H o u r s u n t i l
M e n u
1 0 h r s C h e c k f i l t e r s
1 0 h r s C h e c k n o z z l e s
5 0 h r s G r e a s e p o i n t s
1 0 0 h r s T i g h t e n b o l t s
2 5 0 h r s M i s c . c h e c k
W o r k h o u r s r e m a i n i n g f o r e a c h
p a r t u n t i l n e x t s e r v i c e i s
r e c o m m e n d e d
will remain present until the
S e r v i c e i n t e r v a l r e s e t
M e n u
C h e c k f i l t e r s r e s e t
C h e c k n o z z l e r e s e t
G r e a s e p o i n t s r e s e t
T i g h t e n b o l t s r e s e t
M i s c . c h e c k r e s e t
P r e s s E n t e r t o r e s e t h o u r
c o u n t e r , E S C t o l e a v e
u n c h a n g e d
65