Register Readout And Selection - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

5 - Operation

Register Readout and Selection

The register is identified by a number in the upper right corner of the work display. The data is memorized when the system
is switched off.
In this menu it is possible to see the register used for logging individual spray data.
To Read the Data in the Active Register
1. Go to menu [1.3.1 Show register spray data 1].
2. Press
to enter register and read main data.
3. Press
again to see spray data.
4. Press
to exit the menu.
To Read the Totals of Registers
1. Go to menu [1.3.3 Total register].
2. Press
to enter the register and read main data.
3. Press
again to see spray data.
4. Press
to exit the menu.
To Reset Register
Press to reset register.
μ
ATTENTION! Reset of a register can not be stopped, as pressing
÷
NOTE! The active register number is always visible in the right upper corner of the display.
86
S e l e c t r e g i s t e r
M e n u
S h o w r e g i s t e r s p r a y d a t a 1
S e l e c t r e g i s t e r
T o t a l r e g i s t e r
U s e r e g i s t e r 1 t o 9 9 f o r j o b .
S c r o l l t o r e g i s t e r , t h e n p r e s s
E n t e r t o s h o w d a t a
S e l e c t r e g i s t e r
M e n u
S h o w r e g i s t e r s p r a y d a t a 1
S e l e c t r e g i s t e r
T o t a l r e g i s t e r
S h o w s r e g i s t e r n u m b e r 0 w h i c h
i s a t o t a l o f a l l r e g i s t e r s
will immediately reset the register!