Menu 4.3 Test Menu; Menu 4.4 Speed Simulation; Menu 4.5 Emergency Mode - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

3 - Description

Menu 4.3 Test Menu

All readouts for the transducers are in accumulated counts, i.e. one
signal gives one count, except for the optional (analogue)
transducer that is read in milliampere.
1. Go to the "Test of sensors" menu.
2. Choose the item to be tested with up or down arrows and
press to open the menu.
3. Activate sensor as described in the menu, and see if the
signal is detected.

Menu 4.4 Speed simulation

In this menu the speed may be simulated for certain purposes.
A two figure value may be entered.
μ
ATTENTION! The state remains valid until the Controller is
restarted or the value is set to 0.00 km/h.
μ
ATTENTION! Value set to 0.00 km/h means OFF.

Menu 4.5 Emergency Mode

This menu bypasses the system so all relevant sensors are ignored.
Then it is possible to manually fold the boom, align track or operate
valves in order to drive home for service.
The sensor status and voltages can be checked, which is useful for
the HARDI service to solve the problem.
μ
ATTENTION! Do not use the emergency limp home modes unless a problem has occurred. This is not for use during
normal operation.
66
T e s t M e n u
M e n u
F l o w S p e e d O p t i o n a l s e n s o r s
A c t i v e k e y s
P r i m e F l o w t e s t
I n p u t t e s t
F l u i d a n d v a l v e t e s t
P r i m e F l o w S M C U s t a t u s
P r i m e F l o w m o t o r s t a t u s
T r a c k s e r v i c e m e n u
A c t i v a t e f u n c t i o n t o m o n i t o r
s e n s o r ( e . g . d r i v e f o r w a r d s ,
s t a r t f l o w )
S p e e d s i m u l a t i o n
k m / h
K e y i n s p e e d v a l u e . T o d i s a b l e
s i m u l a t i o n k e y i n 0 o r p o w e r
o f f
E m e r g e n c y M o d e
M e n u
B o o m i n e m e r g e n c y l i m p h o m e
T a n k i n e m e r g e n c y l i m p h o m e
T r a c k i n e m e r g e n c y l i m p h o m e