Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book page 124

7 - Fault Finding
ID Type Fault Text at Display
(PG)
96 Changed Track is Locked
97 Changed Reversing
98 Reminder AutoFill setpoint reached
99 Alarm PrimeFlow data cable weakness
100 Alarm Low Prime- Flow voltage
101 Warning PrimeFlow power cable defect
102 Warning PrimeFlow computer defect
103 Warning Fold with unlocked pendulum
105 Changed Agitation in auto
107 Warning Slant angle sensor fault
108 Alarm Boom height sensor fault
110 Warning Tank sensor fault
112 Changed Flat 1 Level 1 Hilly 5
113 Changed Flat 1 Level 2 Hilly 5
114 Changed Flat 1 Level 3 Hilly 5
115 Changed Flat 1 Level 4 Hilly 5
116 Changed Flat 1 Level 5 Hilly 5
117 Warning D-centre incorrect position
118 Warning Pendulum locking failed
119 Warning Pendulum release failed
120 Warning STOP! PENDULUM LOCKED!
121 Alarm Pendulum lock sensor
122 Warning Edit filled above content
123 Warning Folding not allowed
124 Reminder TODO_1
125 Reminder TODO_3
126 Reminder NO DILUTION
127 Reminder TANK DILUTION
128 Reminder BOOM DILUTION
131 Warning Boom not in transport
132 Illegal action One function only
133 Illegal action Unfold inner wing
134 Illegal action Keep folding 1st outer wing
135 Illegal action Keep folding 2nd outer wing
124
Criteria for Fault
Operations Disabled
Warning is active when 2.2.4.3 Slant mirror is
enabled and/or if 2.2.4.4 Slant in steps is
enabled.
The warning is generated, if the sensor signal
is less than0.2 Volt or exceeds 4.8 Volt.
Appears when dilution kit function is
activated, and no outputs are active.
Appears when dilution kit function is
activated, and tank output is active.
Appears when dilution kit function is
activated, and Boom output is active.
Help Text
Check sensor and cable on pendulum.
Disable HeadlandAssist.
Disable Slant in steps.
Fluid systems works normally.
Suction from rinse tank.
Flush tank through tank cleaning nozzles.
Suction from rinse tank.
If nozzles are open - flush feed hoses.
If nozzles are closed - flush dump hose.