Autoselect - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

AutoSelect

μ
ATTENTION! This system requires a pneumatic air system available to drive the AutoSelect. Take compressed air from
the tractor compressor, the sprayer pneumatic brake system or a separate electric compressor with tank fitted in the
ChemLocker.
If the sprayer is fitted with 2 sets of boom lines this function can be used to ensure volume rate and droplet size is maintained
during large changes to forward speed. Controlled by the DynamicFluid4 system, this can help in following situations:
• Operator can select or change nozzle from the driver seat.
• For example using a specific drift reduced nozzle on headland or in buffer zones.
• Increased working speed without compromises.
• Operator can react on wind condition and direction. With rear wind, a higher driving speed is possible when switching
nozzles.
• Operator can change volume rates and dose rates easier in the field and still have a good spray quality.
Choose the right menu for your spraying job. When AutoSelect is active, it will be shown in the display with an icon that
show the actual status.
AutoSelect in the Controller
• The system is set up in menu 2.2.3 if it is active. See System Setup chapter.
• The boom lines are pronounced:
• A for front boom lines.
• B for rear boom lines.
• The AutoSelect can be set up to react on pressure.
AutoSelect can be used for four main application methods:
1. To manually switch between nozzle types with the same output.
As spraying conditions change during the course of the day it may be an advantage to change from an F-series nozzles
to LOWDRIFT series nozzles to overcome off target wind drift (or LOWDRIFT to INJET as the case may be).
Status icons are:
icon is shown when line A is active and in manual mode.
icon is shown when line B is active and in manual mode.
2. To manually switch to a larger or smaller nozzle size.
If there is a requirement to change the application rate during spraying, or between spraying tasks.
Status icons are:
icon is shown when line A is active and in manual mode.
icon is shown when line B is active and in manual mode.
3 - Description
31