Autowash Programs - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

5 - Operation

AutoWash Programs

There are 3 wash programs available.
BoomFlush
1. Go to AutoWash by pressing
2. Press
to enter BoomFlush.
3. Begin driving in the field just sprayed (A). Spray at normal driving
speed to avoid over-dosing.
4. Press
to start the program.
5. In field (A), drive approximately 500 metres (9 km/h) until
BoomFlush has finished.
÷
NOTE! When doing a BoomFlush the MainTank contents will be increased with 40 litres. This is solely spray-liquid that
are primed back to the MainTank before clean rinse water is directed to the nozzles.
The following diagram show the valve positions during the BoomFlush program.
11:14
12:14
13:14
14:14
102
.
Pressure Suction
SmartValve SmartValve
A
Main Spray CycloneFilter
ON/OFF Boost Line
Valve
Agitation
Valve