Menu 2 Setup; General Info; Menu 2.1 Display Readout - Hardi SMARTCOM ISOBUS UT SW A.2.2 Series Original Instruction Book

3 - Description

Menu 2 Setup

General Info

The following menu explanations assume you have mastered the general keystrokes and you can "find your way" to the
specific menu. If this is not so, please re-read section "Terminals and Boxes" on page 13.

Menu 2.1 Display readout

It is possible to freely choose which functions to be shown in the display.
For a full list of possible readouts, please refer to the following menus in "Full Menu Structure" on page 37:
• Menu 2.1.1
• Menu 2.1.2
• Menu 2.1.3
• Menu 2.1.4
÷
NOTE! As some readouts need extra sensors, the relevant sensor has to be connected to get a readout.
The ISOBUS Terminals has 5 different informational windows A, B,
C, D and E.
Window A will always show the actual volume rate.
The large window shows the same as window A, as default. This
can be changed to another readout by pressing one of the preset
keys. However, this readout will change back to show the actual
volume rate when the controller is rebooted.
Menu 2.1.5 Show ESC softkey to leave
In menu 2.1.5 it can be selected how the ESC key is operated.
• Menu 2.1.5.1:
Select this menu if there is no ESC button on the ISOBUS
Terminal.
• Menu 2.1.5.2:
Select this menu if the ISOBUS Terminal has a physical ESC
button.
μ
ATTENTION! Do only select menu 2.1.5.2 if the ISOBUS
Terminal has a physical ESC button!
46
B o o m p r e s s u r e S l a n t a n g l e P r o g . r a t e
b a r d e g r e e l i t e r / h a
B o o m p r e s s u r e P r o g . r a t e
l i t e r / h a
P r o g . r a t e
b a r
l i t e r / h a