Parameter List With Instruction Codes - Mitsubishi Electric FR-E700 Series Instruction Manual

Appendix
A.4

Parameter list with instruction codes

In the initial setting status, simple mode parameters and extended parameters can be displayed. Set
Pr. 160 "User group read selection" as required. So check the setting of Pr. 160 if parameters are not
shown or change the setting of Pr. 160 to lock parameters.
Parame-
ter
160
Tab. A-4:
NOTES The parameters marked
The parameters marked with
tion even if "0" (initial value) is set in Pr. 77 "Parameter write selection".
Parameters for the option are displayed only when the option unit is installed.
The instruction codes (hexadecimal) for "read" and "write" on the right of the parameter number
are those used to set the parameter via communication. "Extended" indicates the setting of the
extended link parameter. (Refer to section 6.19 for communication.) The data code is contained in
the table columns to the right next to the parameter number.
The symbols in the table have the following meanings:
✔: Setting the parameter is possible for this operation mode.
—: Setting the parameter is impossible for this operation mode.
Instruction Code
Parame-
Function
ter
0 00
1 01
2 02
3 03
4 04
Basic functions
5 05
6 06
7 07
8 08
9 09
Tab. A-5: Parameter list with instruction codes (1)
FR-E700SC EC
Name
User group read
selection
Settings of parameter 160
are the simple mode parameters.
Name
80 0 Torque boost
81 0 Maximum frequency
82 0 Minimum frequency
83 0 Base frequency
84 0
85 0 Multi-speed setting
86 0
87 0 Acceleration time
88 0 Deceleration time
89 0 Electronic thermal O/L relay
Initial Setting
Remarks
Value Range
Only the simple mode parameters can be displayed.
9999
Simple mode and extended mode parameters can be
0
displayed.
0
Only parameters registered in the user group can be
1
displayed.
in the table allow its setting to be changed during opera-
Control Mode-based Correspondence Table
V/F control
magnetic flux
vector control
✔
✔
✔
✔
✔
RH
✔
RM
✔
RL
✔
✔
✔
Parameter list with instruction codes
General-
Refer to
Advanced
purpose
Page
magnetic flux
vector control
— — 6-33
✔ ✔
6-50
✔ ✔
— — 6-54
✔ ✔
✔ ✔
6-58
✔ ✔
✔ ✔
6-69
✔ ✔
✔ ✔
6-80
Customer
Setting
A - 11