Mitsubishi Electric FR-E700 Series Instruction Manual page 37

Wiring
NOTES
To prevent a malfunction due to noise, keep the signal cables more than 10cm away from the
power cables. Also separate the main circuit wire of the input side and the output side.
After wiring, wire offcuts must not be left in the inverter.
Wire offcuts can cause an alarm, failure or malfunction. Always keep the inverter clean.
When drilling mounting holes in an enclosure etc., take care not to allow chips and other foreign
matter to enter the inverter.
The output of the single-phase power input specification is three-phase 230V.
FR-E700SC EC
Terminal connection diagramm
3 - 5