Command Reference - ILX Lightwave LDT-5900 Series User Manual

Command Reference

The Command Reference presents the commands for remote operation of the
LDT-5900, listed in alphabetical order. See Command Syntax section in Chapter 3
for detailed instructions about using the commands.
BEEP
Action
Parameters
Example
BEEP?
Action
Response
Example
CAL:
01_10
The BEEP command is used to enable the beep function on or off. If enabled, the
instrument will beep whenever a key is pressed.
One <nrf> value is required. 0 = beep off, 1 = beep on.
BEEP 1 action: Turns the beep function on.
The BEEP? query is used to report the state of the beep function.
The returned value is either a 0 or a 1. 0 = beep off, 1 = beep on.
BEEP? response: 1: The beep function is on..
The CAL: root command path is used to access the calibration commands and queries.
The following commands may be reached from the CAL: command path.
CAL:COARSEDAC
CAL:COARSEDAC?
CAL:DEFault
CAL:ITE
CAL:ITE?
CAL:RAC
CAL:RAC?
CAL:SAVE
CAL:SENsor:VOLTage:10UA
CAL:SENsor:VOLTage:10UA?
CAL:SENsor:VOLTage:100UA
CAL:SENsor:VOLTage:100UA?
C O M M A N D R E F E R E N C E
Comm a nd Reference
CAL:SENsor:VOLTage:1MA
CAL:SENsor:VOLTage:1MA?
CAL:SOURCE:SENsor:10UA
CAL:SOURCE:SENsor:10UA?
CAL:SOURCE:SENsor:100UA
CAL:SOURCE:SENsor:100UA?
CAL:SOURCE:SENsor:1MA
CAL:SOURCE:SENsor:1MA?
CAL:VTE
CAL:VTE?
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
FRONT PANEL
C
OMMON
D D
EVICE EPENDENT
FRONT PANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
67
LDT-5980/ 5948