ILX Lightwave LDT-5900 Series User Manual page 106

4
C H A P T E R
KEY
Action
Parameters
Example
LIMit:ITE
LIMit:ITE:HIgh
Action
Parameters
Notes
Example
90
LDT-5980/ 5948
C O M M A N D R E F E R E N C E
Com ma nd Reference
The KEY command is used to initiate a front panel key press or knob turn.
One <nrf> value is required. Each key/knob is assigned a specific number.
Key 0 --> Output Enable/Disable
Key 1 --> Enter/Lock
Key 2 --> Up arrow
Key 3 --> Down arrow
Key 4 --> Main/Local
Key 5 --> Parameter Select
Key 6 --> Mode Select
Key 7 --> Reserved
Key 8 --> Reserved
Key 9 --> Reserved
Key 10 --> Dial increment right
Key 11 --> Dial decrement left
KEY 5 action: initiates a key press for the Parameter Select button.
The LIMit:ITE: command path is used to access the ITE limit commands. The following
commands may be reached directly from the LIMit:ITE: command path.
LIMit:ITE:HIgh
LIMit:ITE:HIgh?
LIMit:ITE:LOw
LIMit:ITE:LOw?
The LIMit:ITE:HIgh command sets the upper TE current limit value.
An <nrf value> that represents the upper limit current, in Amps.
Maximum current limit is dependent on the instrument model and the cable type.
LIM:ITE:HI 4.0 action: the upper current limit is set to 4.0 A.
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL