ILX Lightwave LDT-5900 Series User Manual page 89

CAL:SOURCE:SENsor:100UA
Action
Parameters
Notes
Example
CAL:SOURCE:SENsor:100UA?
Action
Response
Notes
Example
CAL:SOURCE:SENsor:1MA
Action
Parameters
Notes
Example
01_10
The CAL:SOURCE:SENsor:100UA is used to enter the calibration coefficient for the 100
µA sensor current source.
One <nrf value> is required representing the 100 µA scale factor.
This is a service related command. Calibration mode should not be entered unless the
user has the proper measurement equipment in place. See the Calibration section of
Chapter 5 for complete calibration instructions
CAL:SOURCE:SEN:100UA 1.234 Action: Scales the original sensor output current at
the 100 µA setting by a factor of 1.234.
The CAL:SOURCE:SENsor:100UA? query returns the calibration coefficient for the 100
µA sensor current source.
The response is one value that represents 100 µA current source calibration coefficient.
See the Calibration section of Chapter 5 for complete calibration instructions.
CAL:SOURCE:SEN:100UA? Response: 1.204, means a scale factor of 1.204 has been
applied for the 100 A current source calibration.
The CAL:SOURCE:SENsor:1MA is used to enter the calibration coefficient for the 1 mA
sensor current source.
One <nrf value> is required representing the 1mA scale factor.
This is a service related command. Calibration mode should not be entered unless the
user has the proper measurement equipment in place. See the Calibration section of
Chapter 5 for complete calibration instructions
CAL:SOURCE:SEN:1MA 1.056 Action: Scales the original sensor output current at the
1mA setting by a factor of 1.056.
C O M M A N D R E F E R E N C E
Comm a nd Reference
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
73
LDT-5980/ 5948