Ieee 488.2 Common Commands; Command Timing - ILX Lightwave LDT-5900 Series User Manual

IEEE 488.2 Common Commands

IEEE 488.2 Common Commands and Queries are distinguished by the "*" which
begins each mnemonic. The diagrams below show the syntax structure for
common commands, common command queries, and common commands with
numeric data required.
Numeric data is required with *PSC (1 = on, 0 = off), *RCL (0 to 9, see Save and
Recall on page 15), *SAV (1 to 9, see Save and Recall on page 15), *ESE (0 to
255, see page 34), *SRE (0 to 255, see page 38), and *PUD (used at factory
only).
The instrument self-test query *TST? will always return 0 since no self-test routine
is incorporated into the unit.
A list of all of the IEEE 488.2 Common Commands supported by the LDT-5900
Series Temperature Controllers follows.
*CLS
*ESR?
*OPC?
*PUD
*RST
*SRE?
*WAI

Command Timing

This section describes, for each command, whether the command is performed in
an overlapped or sequential manner. Command timing states whether the next
command can begin while another command is being executed, or if the next
command must wait until this command is completed before its execution begins.
See Operation Complete Definition on page 40 for information about the operation
complete flag.
01_10
*ESE *ESE?
*IDN? *OPC
*PSC *PSC?
*PUD? *RCL
*SAV *SRE
*STB? *TST?
R E M O T E O P E R A T I O N S
Remot e Comm unica t ion
3
C H A P T E R
49
LDT-5980/ 5948