Figure 2.3 Trigger Out - ILX Lightwave LDT-5900 Series User Manual

GENERAL
Output Connectors
Power Requirements
Size
Weight
Ambient Temperature Range
Humidity
Warm-up
EMC
Safety
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
01_10
TEC I/O
GPIB
RS-232
Trigger In
Trigger Out
All values relate to a five minute warm up period.
Software limits of range. Actual range possible depends on the physical load, thermistor type and TEC module used.
Accuracy figures are set point referenced and represent the uncertainty that the 5948/5980 adds to the measurement. This figure
does not include the sensor uncertainties which can add up to 2
and 100 A current setting for -5
the instrument.
Into a 0.1 to 2.5 load.
Temperature stability measurements made at 25
the avg P-P value over the measurement period.
Measured over the full DC current range into a 1 load.
P=Proportional, I=Integral, D=Derivative. Software programmable terms through the front panel or GPIB.
Thermistor sensing current range software selectable through the front panel or GPIB.
Resistance range 0.3 to 10 with 4-wire voltage sense for rated accuracy.
Higher resolution can be obtained through GPIB; less than 0.1
thermistor current.
I N T R O D U C T I O N A N D S P E C I F I C A T I O N S
LDT-5948
Female 25 pin, D-sub
IEEE-488
Female 9 pin D-sub
BNC
BNC
90 - 260V at 50/60 Hz
3.5" x 7.3" x 12"
10.0 pounds (4.5 kg)
Operating: 10 to 40
Storage: -40 to 70
< 85%, relative, non-condensing
Five (5) minutes to rated accuracy
EN 61326-1:2000 (CE Requirements)
EN 61010-1:2001; 73/23/EEC, 93/68/EEC
o
o o
C to 50 C. Both resolution and accuracy are dependent upon the user-defined configuration of
o
C with a 10 kohm thermistor on the 100 A setting. The number is derived from
Sp ecifica t ions
LDT-5980
o
C
o
C
C. Accuracy figures are quoted for a typical 10 k thermistor
with 10 A thermistor current and <0.01
1
C H A P T E R
with 100 A
7
LDT-5980/ 5948