ILX Lightwave LDT-5900 Series User Manual page 123

SET:ITE
Action
Parameter
Notes
Example
SET:ITE?
Action
Response
Notes
Examples
SET:SENsor
Action
Parameter
Notes
Example
SET:SENsor?
Action
Response
Notes
Examples
01_10
The SET:ITE command sets the constant TE current control setpoint.
A <nrf value> that represents the ITE current setpoint, in Amps, is required.
This setting is always stored, but is only used when the instrument is in ITE control
mode.
SET:ITE 2.5 action: sets the setpoint for ITE mode to 2.5A.
The SET:ITE? query returns the constant TE current setpoint.
The response is a single value that represents the constant ITE set point value, in Amps.
The ITE set point is only in effect when the operating mode is ITE.
SET:ITE? response: -0.5, means the output current set point is -0.5 A.
The SET:SENsor command sets the constant sensor setpoint.
A <nrf value> that represents the constant sensor setpoint is required.
This setting is always stored, but is only used when the instrument is in sensor mode.
The units of the parameter are in dependent upon which sensor is selected, (RTD and
thermistor in Ohms, ICI in Amps, ICV in Volts).
SET:SENsor 0.002932 action: sets the setpoint for the ICV sensor to 2.93mV.
The SET:SENsor? query returns the constant sensor setpoint.
The response is a single value that represents the constant sensor set point value.
The constant sensor set point is only in effect when the operating mode is constant
sensor. The units of setpoint are dependent upon what sensor is selected (i.e. if ICI is
selected, the setpoint will be in Amps).
SET:SEN? response: 19600, means the constant sensor set point is 19.6 k (if the
sensor selected is a thermistor).
C O M M A N D R E F E R E N C E
Comm a nd Reference
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
107
LDT-5980/ 5948