ILX Lightwave LDT-5900 Series User Manual page 86

4
C H A P T E R
CAL:SAVE
Action
Parameters
Notes
Example
CAL:SENsor:VOLTage:10UA
Action
Parameters
Notes
Example
CAL:SENsor:VOLTage:10UA?
Action
Response
Notes
Example
70
LDT-5980/ 5948
C O M M A N D R E F E R E N C E
Com ma nd Reference
The CAL:SAVE is used to save all calibration coefficients in non-volatile memory.
None.
This is a service related command. Calibration mode should not be entered unless the
user has the proper measurement equipment in place. See the Calibration section fof
Chapter 5 for complete calibration instructions.
CAL:SAVE action: Saves all calibration coefficients.
The CAL:SENsor:VOLTage:10UA command is used to enter the calibration coefficients
for the sensor voltage measurement with a 10 A sensor supply current.
Two values are required to set the sensor voltage calibration. The first represents the
slope and the second represents the offset in voltage measurement.
This is a service command. Calibration mode should not be entered unless the user has
the proper measurement equipment in place. See the Calibration section of Chapter 5 for
complete calibration instructions.
CAL:SEN:VOLT:10UA 1,0 action: Enters a slope of 1.0 V/V and an offset of 0 V for the
sensor voltage measurement calibration.
The CAL:SENsor:VOLTage:10UA? query returns the calibration coefficients for the
sensor voltage measurement with a 10 A sensor supply current.
The response is two values; the first represents the calibration voltage measurement
slope and the second represents the voltage offset coefficients.
See the Calibration section of Chapter 5 for complete calibration instructions.
CAL:SEN:VOLT:10UA? Response: 1,0 means a slope of 1.0 V/V and an offset of 0 V for
the sensor voltage measurement calibration.
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL