ILX Lightwave LDT-5900 Series User Manual page 85

CAL:ITE
Action
Notes
Example
CAL:ITE?
Action
Response
Notes
Example
CAL:RAC
Action
Notes
Example
CAL:RAC?
Action
Response
Notes
Example
01_10
The CAL:ITE command is used to enter the calibration coefficients for the TE current
measurement.
This is a service related command. Calibration mode should not be entered unless the
user has the proper measurement equipment in place. See the Calibration section of
Chapter 5 for complete calibration instructions
CAL:ITE 10,0 action: a slope of 10 and offset of 0 is entered for TE current measurement
calibration coefficient.
The CAL:ITE? query returns the TE current measurement calibration coefficients.
The response will be two values; the first represents slope and the second represents
offset.
See the Calibration section of Chapter 5 for complete calibration instructions.
CAL:ITE? response: 4.2, 0.5
The CAL:RAC command is used to enter the calibration coefficients for the TE AC
resistance measurement.
This is a service related command. Calibration mode should not be entered unless the
user has the proper measurement equipment in place. See the Calibration section of
Chapter 5 for complete calibration instructions.
CAL:RAC 10,0 action: a slope of 10 and offset of 0 is entered for TE AC resistance
measurement calibration coefficients.
The CAL:RAC? query returns the TE AC resistance measurement calibration
coefficients.
The response will be two values; the first represents slope and the second represents
offset.
See the Calibration section of Chapter 5 for compete calibration instructions.
CAL:RAC? response: 4.2, 0.5
C O M M A N D R E F E R E N C E
Comm a nd Reference
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
69
LDT-5980/ 5948