Measurement And Setpoint - ILX Lightwave LDT-5900 Series User Manual

2
C H A P T E R

Measurement and Setpoint

By default, the LDT-5900 Series Temperature Controller displays the temperature
measurement from the selected sensor in
keys, the user can change the displayed temperature conversion units (
or the measurement parameter altogether (sensor measurement, TE current, TE
voltage, TE power). After exiting any menu, the instrument will always return to
the measurement display.
Whilte the measurement display is active, the user can access and change the
setpoint for the selected control mode. (See the Mode Section later in this chapter
for details on control modes and setpoints.) Turning the adjust knob will cause the
screen to switch from displaying the measurement to displaying the setpoint. This
is indicated by brackets around the setpoint value. The setpoint value can then be
adjusted with the knob and stored by pressing the ENTER / LOCK key. After 10
seconds of inactivity, the screen will switch back to display the measurement, or
the user can press either DISPLAY / MENU arrow key to immediately switch back
to the measurement display.
16
LDT-5980/ 5948
O P E R A T I O N S
Front Pa nel Opera t ion
LDT-59XX
025.508
o
C. Using the DISPLAY / MENU arrow
TEMPERATURE CONTROLLER
o
C
o o
C, F, K)