ILX Lightwave LDT-5900 Series User Manual page 129

TRIGger:IN
TRIGger:IN:ENABle
Action
Parameters
Notes
Example
TRIGger:IN:ENABle?
Action
Response
Notes
Example
TRIGger:IN:START
Action
Parameters
Notes
Example
01_10
The TRIGger:IN: command path is used to access the input trigger commands. The
following commands can be reached directly from the TRIGger:IN: command path. (See
Trigger In section of Chapter 2 for more information)
TRIGger:IN:ENABle TRIGger:IN:STEPsize
TRIGger:IN:ENABle? TRIGger:IN: STEPsize?
TRIGger:IN:START TRIGger:IN:STOP
TRIGger:IN:START? TRIGger:IN: STOP?
The TRIGger:IN:ENABle command sets enables the trigger input.
An <nrf value> that represents the desired setting is required. The number 1 represents
the input trigger enabled, and number 0 represents the input trigger disabled.
The trigger input will allow an external TTL signal to trigger the instrument to the next
temperature setpoint.
TRIG:IN:ENAB 1 action: Enables the input trigger.
The TRIGger:IN:ENABle? query returns the value of the trigger input enable status.
The response is a single value that represents the input trigger enable status. The
number 1 means the input trigger is enabled, and the number 0 means the input trigger is
disabled.
TRIG:IN:ENAB? response: 0 means the input trigger is disabled.
The TRIGger:IN:START command sets the starting temperature setpoint.
An <nrf value> that represents the desired starting temperature setting is required, in
Valid input range is limited to the LIM:TEMP:HI and LIM:TEMP:LO settings.
TRIG:IN:START 20 action: Sets the starting temperature setpoint to 20
C O M M A N D R E F E R E N C E
Comm a nd Reference
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
o
C.
o
C.
113
LDT-5980/ 5948