ILX Lightwave LDT-5900 Series User Manual page 109

LIMit:SENsor:LOw
Action
Parameters
Notes
Example
LIMit:SENsor:LOw?
Action
Response
Notes
Example
LIMit:Temp
01_10
The LIMit:SENsor:LOw command sets sensor lower limit value.
An <nrf value> that represents the lower sensor limit. Units depend on which sensor is
selected. For thermistor and RTD units are Ohms, for ICI Amps, and for ICV Volts.
Acceptable values for thermistors are 1 to 600000 .
Acceptable values for RTD are 0.1 to 60000.0 .
Acceptable values for ICI are 0.000010 to 0.000600 Amps.
Acceptable values for ICV are 0.100 to 6.000 Volts.
The maximum lower limit value will be determined by the value set by the
LIMit:SENsor:HIgh command.
By default, the controller output is turned off when the sensor measurement falls below
mode. This feature can be disabled by clearing bit 12 in the Output
this setting in R
snsr
Off Enable Register 0, using the ENABle:OUToff command.
LIM:SEN:LO 95.2 action: Sets the sensor lower limit to a minimum of 95.2
The LIMit:SENsor:LOw? query returns the value of the sensor lower limit setting.
The response is a single value that represents the lower sensor limit and the units
depend on which sensor is selected. For thermistor or RTD the value will be in Ohms, for
ICI Amps, and for ICV Volts.
This limit is only in effect in Rsnsr mode.
LIM:SEN:LO? response: 1200.000 when thermistor is selected means a lower sensor
limit of 1200 Ohms.
The LIMit:Temp: command path is used to access the temperature limit commands. The
following commands may be reached directly from the LIMit:Temp: command path.
LIMit:Temp:HIgh
LIMit:Temp:HIgh?
LIMit:Temp:LOw
LIMit:Temp:LOw?
C O M M A N D R E F E R E N C E
Comm a nd Reference
4
C H A P T E R
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
.
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
C
OMMON
D D
EVICE EPENDENT
F P
RONT ANEL
93
LDT-5980/ 5948