ILX Lightwave LDT-5900 Series User Manual page 112

High power temperature controller, precision temperature controller
Table of Contents

Advertisement

4
C H A P T E R
LIMit:VTE
LIMit:VTE:HIgh
Action
Parameters
Notes
Example
LIMit:VTE:HIgh?
Action
Response
Notes
Example
LIMit:VTE:LOw
Action
Parameters
Notes
Example
96
LDT-5980/ 5948
C O M M A N D R E F E R E N C E
Com ma nd Reference
The LIMit:VTE: command path is used to access the VTE limit commands. The following
commands can be reached directly from the LIMit:VTE: command path.
LIMit:VTE:HIgh
LIMit:VTE:HIgh?
LIMit:VTE:LOw
LIMit:VTE:LOw?
The LIMit:VTE:HIgh command sets upper TE voltage limit value.
An <nrf value> that represents the upper voltage limit, in Volts, is required.
Acceptable values are -12.0V to +12.0V. The output will only be disabled when the
voltage exceeds this limit when the instrument is in VTE mode. In all other modes,
the output will not be disabled when this voltage is reached, but the Voltage Limit LED
indicator will illuminate. The output can be turned off for all operational modes when this
limit is reached by enabling bit 6 of Register 0 through the ENABle:OUTOFF command.
LIM:VTE:HI 6.0 action: Sets the upper voltage to 6.0V.
The LIMit:VTE:HIgh? query returns the value of the upper TE voltage limit setting.
The response is a single value that represents the upper voltage limit.
This limit is only in effect in VTE mode or when bit 6, Register 0 of the ENABle:OUTOFF
is set true.
LIM:VTE:HI? response: 5.5 means an upper voltage limit of 5.5V.
The LIMit:VTE:LOw command sets lower TE voltage limit value.
An <nrf value> that represents the lower voltage limit, in Volts, is required.
Acceptable values are -12.0V to +12.0V. The output will only be disabled when the
voltage exceeds this limit when the instrument is in VTE mode. In all other modes,
the output will not be disabled when this voltage is reached, but the Voltage Limit LED
indicator will illuminate. The output can be turned off when this limit is reached by
enabling bit 7 of Register 0 through the ENABle:OUToff command.
LIM:VTE:LO -4.0 action: Sets the lower voltage to -4.0V.
C
OMMON
D
D
EVICE
EPENDENT
F
P
RONT
ANEL
C
OMMON
D
D
EVICE
EPENDENT
F
P
RONT
ANEL
C
OMMON
D
D
EVICE
EPENDENT
F
P
RONT
ANEL
C
OMMON
D
D
EVICE
EPENDENT
F
P
RONT
ANEL

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ldt-5980Ldt-5948

Table of Contents