[Settings] - Ricoh Ri 2000 User Manual

[Settings]

① Perform controls of ink path. From this menu, you can flush the printer - refer to section 8.5
② Options page 1 - IP address (set print IP address), Drying time (set time between white layer
printing and CMYK printing), Height Settings (Can set the tolerance for how much variation is a
llowed on the printing surface before the height sensor rejects the print attempt, Default is set
at .3mm and should be used for most fabrics), temperature (C/F) (Can display temperature in
Celsius or Fahrenheit) High speed mode on/off (Can set white layer to high speed mode – not
recommended though because of the ink mist) white clean frequency allows you to set how
often the white heads are cleaned based on printing activity.
Page 2 - Language select the display language, stored jobs options (if selected, jobs in
ernal memory will be deleted after a selected # of days, the default is this is tuned off so
bs are not deleted), factory reset (Set Head. Table and print alignment to original settings),
Volume – allows you to change the volume of the audible beep that occurs when the printer ha
s finished a print. The default is set to 20
③ Display printer general information. Serial #, Control panel firmware ver. Engine (CTL) firmware
version, Sub control board firmware version.
RICOH Ri 2000
User Manual
int
jo
34