Ricoh Ri 2000 User Manual page 124

Pull out the holder by pulling the green handle – there are no screws to loosen. Remove the old filter
and install the new filter by sliding the filter under the green hook on the end opposite the green
handle.
Make Sure when putting the filter and holder back in the printer the square opening is pointing up
towards the top of the printer (nod the round opening in the holder). This will make the orientati
on of the green handle towards the top of the printer. If it is installed in the reverse (round
opening pointing up) then the handle will be too low and the carriage will hit in causing and er
ror and possible damage to the printer.
5.2 Alignment adjustments after part replacement
This section describes alignment adjustments that may be necessary after replacing parts (carriage,
•
CTL – or control board, sub control board)
These functions can be performed on the
•
tab.
RICOH Ri 2000
User Manual
124