Connecting The Power Cord - Thermo Scientific thermoscientific Vanquish Pumps C Operating Manual

5.5.3

Connecting the Power Cord

Pumps C, Pumps F ( VC-Pxx, VF-Pxx)
Operating Manual
NOTICE
Condensation in a device can damage the electronics.
• Before connecting the devices to the power line, be sure that no
condensation is present in the devices.
• If you suspect that condensation is present, allow the device to
warm up to room temperature slowly. Wait until the condensation is
completely gone before proceeding.
1. Verify that the power switch on the device is set to OFF.
2. Connect the power cord to the power inlet connector on the device.
3. Connect the free end of the power cord to an appropriate power
source.
5 • Installation
Page 55